Hello! New to MoOde, but loving it so far.
Question:
Does MoOde support USB Audio input? e.g. plug the USB cable from an iPhone into a USB port on the Pi and stream audio? I tried it and it doesn't seem to work natively, but maybe there's a setting I need to set?
Thank you for your help!
-Andy.
Not possible using male-to-male cable and according to the following article there is a risk of damage.
https://raspberrypi.stackexchange.com/qu...hrough-usb
With iPhone just turn on the Airplay renderer in moOde Audio Config and then use Airplay on the iPhone to stream audio.
-Tim
Right, of course. The connector on the RPI is reversed from what I'd need. Is the micro-USB on the RPI an OTG USB port by chance?
I think it is. I use a USB OTG cable on my Zero W.
Better check the specs. I seem to recall reading that only the Zero is OTG.
Regards,
Kent
Sorry, I meant the Zero series as opposed to the 2,3,4 series.
The Pi4 has otg via the usb-C socket.... (and like the Pi Zero and Zero-W can be used as in usb-Gadget mode.)
https://raspberrypi.stackexchange.com/qu...-b-located
Also worth noting the Pi4 does not have poly-fuse protection on the usb-c power input.... previous Pi (except the above mentioned Zero') did have poly-fuse on the micro-usb power.
This means powering via the header pins is the same as powering via the usb-C and so frees up the usb-C for otg use.
Ah, should have stopped while I was ahead (with 2 and 3) but I fell into my Buzz Lightyear persona---to infinity and beyond!
Ok, cool!
So with the RPI4, any idea how to use the USBC for USB Audio input along with MoOde?