Moode Forum
[PROBLEM] Moode only plays one song then the mpd server is disconnected - Printable Version

+- Moode Forum (http://moodeaudio.org/forum)
+-- Forum: moOde audio player (http://moodeaudio.org/forum/forumdisplay.php?fid=3)
+--- Forum: Support (http://moodeaudio.org/forum/forumdisplay.php?fid=7)
+--- Thread: [PROBLEM] Moode only plays one song then the mpd server is disconnected (/showthread.php?tid=2022)



Moode only plays one song then the mpd server is disconnected - datstartup - 12-28-2019

Hi,

My Raspberry Pi 3 is loaded with Moode 6.4.0. The audio output is bluetooth speaker and wifi device is the onboard one.

The configuration and connecting speaker are fine, but it only plays one song before the interface freeze. Change it to library view also give a empty interface. Other configuration options are fine, the main menu is fine and I still can reboot. After reboot, I have the play and library interfaces again, then play one song and the problem is back.

I have tried to reload the image but the same thing happen.

I also have tried to use mpdroid on my phone but same one song then disconect symptom.

My experience with Moode is near perfect until I realize this major problem.

Below is the log (/var/log/mood.log).

Code:
20191228 090321 worker: -- Start
20191228 090322 worker: Successfully daemonized
20191228 090322 worker: Integrity check (passed)
20191228 090322 worker: Session loaded
20191228 090322 worker: Debug logging (off)
20191228 090322 worker: Device raw: Card0 (ALSA) | Card1 () | I2Sdev (none)
20191228 090322 worker: Device cfg: Name (On-board audio device) | Card (0) | MPDdev (0) | Mixer (PCM) | Alsavol: (0)
20191228 090323 worker: ALSA volume set to (0%)
20191228 090323 worker: -- System
20191228 090327 worker: Host name     (moode)
20191228 090327 worker: moOde release (6.4.0 2019-11-24)
20191228 090327 worker: Raspbian OS   (10.2)
20191228 090327 worker: Linux kernel  (4.19.83-v7+ #1277)
20191228 090327 worker: Platform      (Pi-3B 1GB v1.2)
20191228 090327 worker: Architecture  (armv7l)
20191228 090327 worker: MPD version   (0.21.16)
20191228 090327 worker: CPU governor  (ondemand)
20191228 090327 worker: USB boot not enabled yet
20191228 090327 worker: File system not expanded yet
20191228 090327 worker: HDMI port on
20191228 090328 worker: File check (OK)
20191228 090328 worker: -- Network
20191228 090328 worker: eth0 exists
20191228 090328 worker: eth0 wait 0 for IP address
20191228 090331 worker: eth0 wait 1 for IP address
20191228 090334 worker: eth0 wait 2 for IP address
20191228 090337 worker: eth0 wait 3 for IP address
20191228 090350 worker: eth0 wait 4 for IP address
20191228 090353 worker: eth0 address not assigned
20191228 090353 worker: wlan0 exists
20191228 090353 worker: wifi country (US)
20191228 090353 worker: wlan0 trying SSID (XX)
20191228 090354 worker: IP addr (192.168.1.XX)
20191228 090354 worker: Netmask (255.255.255.0)
20191228 090354 worker: Gateway (192.168.1.X)
20191228 090354 worker: Pri DNS (XXX)
20191228 090354 worker: Domain  (Home)
20191228 090354 worker: -- Audio
20191228 090354 worker: ALSA outputs unmuted
20191228 090354 worker: ALSA card number (0)
20191228 090354 worker: Audio output (On-board audio device)
20191228 090355 worker: Audio formats (U8, S16_LE)
20191228 090355 worker: ALSA mixer name (PCM)
20191228 090355 worker: MPD volume control (software)
20191228 090355 worker: Hdwr volume controller exists
20191228 090355 worker: Max ALSA volume (100%)
20191228 090355 worker: -- Services
20191228 090355 worker: Reset renderer active state
20191228 090356 worker: MPD conf updated
20191228 090356 worker: MPD started
20191228 090356 worker: MPD accepting connections
20191228 090356 worker: Configure MPD outputs
20191228 090357 worker: MPD output 1 ALSA default (off)
20191228 090357 worker: MPD output 2 ALSA crossfeed (off)
20191228 090357 worker: MPD output 3 ALSA parametric eq (off)
20191228 090357 worker: MPD output 4 ALSA graphic eq (off)
20191228 090357 worker: MPD output 5 ALSA polarity inversion (off)
20191228 090357 worker: MPD output 6 ALSA bluetooth (on)
20191228 090357 worker: MPD output 7 HTTP stream (off)
20191228 090357 worker: MPD crossfade (off)
20191228 090357 worker: Audio source (Local)
20191228 090357 worker: Output device (Bluetooth)
20191228 090357 worker: Bluetooth controller started
20191228 090403 worker: Bluetooth controller initialized
20191228 090403 worker: Bluetooth pairing agent started
20191228 090403 worker: USB auto-mounter (udisks-glue)
20191228 090403 worker: -- Music sources
20191228 090403 worker: USB sources (none attached)
20191228 090403 worker: NAS and UPnP sources (none configured)
20191228 090403 worker: -- Miscellaneous
20191228 090403 worker: Saved MPD vol level (0)
20191228 090403 worker: Preamp volume level (0)
20191228 090403 worker: MPD volume level (0) restored
20191228 090403 worker: ALSA volume level (100%)
20191228 090403 worker: Auto-play (Off)
20191228 090403 worker: Maintenance interval (6 hrs)
20191228 090403 worker: Screen saver activation (Never)
20191228 090403 worker: Session permissions (OK)
20191228 090403 worker: Watchdog started
20191228 090403 worker: Ready
20191228 090409 watchdog: INFO Audio output is (closed)
20191228 090827 command/index: Connection to MPD failed
20191228 090829 moode.php: MPD connect failed: cmd=(lsinfo)
UPDATE:

(I come from Volumo and this is the first time I use Moode).

I loaded a Moode 6.3.0 version and everything works like a dream now. How elegant the bluetooth is implemented!

So never mind the problem.