moOde 5.0 Release Candidate RC1

[Tim Curtis]

Unlikely unless you actually use the gpio-config screen to configure and enable pin 25 and then turn on the GPIO button handler in System config. I have a rotary encoder that uses gpio 23 and 24 and no issues with moOde 5.0.

Some commands that may help in troubleshooting:

Print table that shows mapping between GPIO, BCM (Broadcom) and WiringPi pin numbering.

Code:

gpio readall

Read state of pin (WiringPi pin number 6 = BCM 25)

Code:

gpio read 6

- or -

watch -n .5 "gpio read 6"

Is there a script that controls the IR receiver? Maybe its printing an error or has some way to enable debug.

-Tim