07-25-2019, 11:06 AM
Hi All,
@ghoeher - Correct, I did try after a while, so I restarted and tried the command. It cam back between 2 and 10 until the screen displayed (2 minutes later) and the value started to go up to just over 1000 each time I ran the command.
@Georg - I ran you commands, restarted and indeed fixed the issue. The screen came up within 10 seconds of powering on. I tried the entropy_avail command and it came back with a value over 2000.
Tried restarting a few times, and the screen is always shown within 10-15 secs of startup... Another one fixed.
Thanks,
Rob
@ghoeher - Correct, I did try after a while, so I restarted and tried the command. It cam back between 2 and 10 until the screen displayed (2 minutes later) and the value started to go up to just over 1000 each time I ran the command.
@Georg - I ran you commands, restarted and indeed fixed the issue. The screen came up within 10 seconds of powering on. I tried the entropy_avail command and it came back with a value over 2000.
Tried restarting a few times, and the screen is always shown within 10-15 secs of startup... Another one fixed.
Thanks,
Rob
Pi 4B 2GB, HiFi Berry Digi+, Original 7" Raspberry Pi Screen, Ethernet Connected, Sandisk Ultra10 SD card, 5amp power supply (Drives the PI and Screen separately) streaming audio via NFS shares from QNAP NAS.
