The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 906 - File: showthread.php PHP 7.2.34 (Linux)
File Line Function
/showthread.php 906 errorHandler->error



Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


Small audio setup for kitchen
#1
Hi all,
after building my network streamer for the main room in my house (using RPi3 + HifiBerry DAC PRO + ) and connected to my stereo integrated amplifier, I'd like to build a small system to play music in my kitchen. 
Requirements:
1) An all-in-one system RPI based, with additional Amp+DAC board
2) A couple of small bookshelf (for this I could probably reused a couple of  dismissed bookshelf speakers)
3) Eventually using powered with a power bank (no electrical plug close to the shelf on which I'd like to place the system
4) Sources would be Internet Radios and TIDAL (I have an Hi-Fi  account used also in my network streamer), plus occasionally Spotify via AirPlay
5) A knob to manage volume
6) No display
7) Hopefully a momentary button to turn on/off the system
8) Optionally an headphone output, in alternative the possibility to connect a Bluetooth headphone

and obviously Moode as a software player !!!

QUESTIONS:

1) The first issue will be the choice of the Amp Board , clearly shall be an HAT Amp board, having built-in DAC capabilities and able to connect a couple of speakers. I've seen a lot of models and producers (HifiBerry of course,  Suptronics, Audiophonics, JustBoom, etc).  Another requirement (even if having minor priority) is to have already soldered (or even not at all requiring soldering) to make available the 40-pins extension header.  Any suggestion about the amp HAT board?

2) The other question is about the volume control. In my streamer I disabled it, letting to manage it through the amplifier knob. Here, not having a separate amplifier, I think I'd have to use a physical knob, or is it enough to set it as "software" in the Moode settings, and managing it through Moode web UI ?

3) The third problem is the power. Clearly shall be better to have a button to safely shutdown and start the RPI (in the network streamer I used a Mauseberry specific micro-board to manage it, here there's no space to do it). Alternative to the plugging-unplugging of the power cable should be a switch on the cable (similar to the one used in the lamps), this avoid to damage the power slot of the board, but can be dangerous for the RPI and the running software on board).

4) Finally a case, I'd like to have a ready-to-use case, but the selection I think strictly depends by the above points (an hole  for a knob, an hole for the button...)

Any suggestion is welcome !
Thanks in advance 
Andrea
Reply


Messages In This Thread
Small audio setup for kitchen - by mancio61 - 07-29-2019, 02:56 PM
RE: Small audio setup for kitchen - by Tim Curtis - 11-21-2019, 11:32 AM
RE: Small audio setup for kitchen - by Norbert - 11-21-2019, 03:59 PM

Forum Jump: