moOde release 4.1

[Tim Curtis]

Installed MoOde 4.1 without a hitch, again, thanks Tim! (Donation made)

I've noticed that since upgrading from 4.0 to 4.1 I'm getting over modulation  and distortion with upper bass. My setup is Rpi3, MoOde 4, USB to Arcam rPac (DAC), Primare i30 amp and Proac Studio 148's..

I've disabled volume control so its at full output..

I didn't have any audio issues at all with MoOde 4.0 but with 4.1 its really noticeable, when playing tracks that are a bit 'hot' I get a nasty distortion close to clipping even at very low volume on the amp..

Any ideas guys?

Thats odd. If your DAC supports hardware volume then:

1. Run the alsamixer command from an SSH session and verify that ALSA volume = 100 and dB gain = 0.
2. Try reducing ALSA volume in the Audio config screen.

-Tim