Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


static playing high bitrate FLAC files
#9
@poodytang 

DRONE7 is quite right that your system may be marginally powered and I would fix that problem for its own sake.

Nevertheless, the noise you describe does not sound like a power problem to me. If the drive were under-powered and hence slow to respond, I would expect you to experience buffer underruns which result in audio dropout rather than "static or white noise on the track with very high levels of distortion." An easy way to test is to copy some of your problematic files to your uSD card, disconnect the drive, and see if you still get the same noise or not when playing the files. If you don't, then yeah, the drive and power are suspect.

If you do however, then, as TIm said, this is reminiscent of a different issue. Since the pi2aes docs claim it "converts the RPi I2S stream to AES3/SPDIF formatted data at 24-Bit up to 192Khz Frame Rate" it would seem like starting with 24-bit material would be ok. Nevertheless, you can try what was suggested.

FYI, I have a number of "high def" files I've downloaded from 2L to an SSD that is plugged into and powered by an RPi4B+. They are "24-bit/88kHz" and "24-bit/176kHz" FLAC and play back without any issue through my Khadas Tone 1 board. SoX is not enabled. Because of the USB handshake with moOde in which the board advertises itself as capable of S16_LE and S32_LE (but not S24_LE), the 24-bit samples are being byte-extended to 32-bit on output, so the output stats are 32-bit/176.1kHz.

Regards,
Kent
Reply


Messages In This Thread
RE: static playing high bitrate FLAC files - by TheOldPresbyope - 01-18-2021, 06:45 PM

Forum Jump: