01-20-2021, 04:38 PM
(This post was last modified: 01-20-2021, 04:41 PM by TheOldPresbyope.
Edit Reason: added a few words
)
I'm not aware of an RPi 4 Model " B+". I think the "+" is bogus. From time to time the RPF has issued new revisions of the RPi 4 board (see revision codes).
What does System Info say for your setup? (either moodeutl -s from the command line or m>System info from the Sys Config panel in the moOdeUI)
Here's the head stanza for one of my players
If the "Platform" line is empty then moOde didn't recognize your board because its revision code is newer than the list stored in moOde. That's what Tim is adjusting for the next release.
There is no change in any of the routines, however, so it's a simple addition to the list.
Regards,
Kent
What does System Info say for your setup? (either moodeutl -s from the command line or m>System info from the Sys Config panel in the moOdeUI)
Here's the head stanza for one of my players
Code:
pi@moode:/var/www/inc $ moodeutl -s|more
Generating info...
S Y S T E M P A R A M E T E R S
moOde release = 7.0.1 2020-12-23
RaspiOS = 10.6
Linux kernel = 5.4.77-v7l+ #1371
Platform = Pi-4B 1GB v1.1
Architecture = armv7l (32-bit)
System uptime = up 22 hours, 11 minutes
Timezone = America/New_York
Current time = 2021-01-20 11:27:45
If the "Platform" line is empty then moOde didn't recognize your board because its revision code is newer than the list stored in moOde. That's what Tim is adjusting for the next release.
There is no change in any of the routines, however, so it's a simple addition to the list.
Regards,
Kent