Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


Problem: GPIO debounce not working
#5
(06-24-2019, 01:20 PM)Tim Curtis Wrote: I don't disagree however I'm not the dev responsible for the GPIO class library used in moOde's GPIO Buttons module. You would need to contact the maintainer of RPi.GPIO https://pypi.org/project/RPi.GPIO/

The script used in moOde is located in the directory below
/var/www/command/gpio-buttons.py

-Tim
Tnx,

Send the request / feedback to the maintainer of the RPI.GPIO
Once I got feedback, I will post it here.

For the meantime to "solve" my issue, i will invert the signal:
I will use a N-FET to have the GPIO at 0V (solid!!) when the supply is ok.
(The FET will five me a few milli-ohm connection, iso a 2K pull up)


This should reduce the EMI influence. Its not good, but should work.
Most likely after the weekend.

Regards,
Jeroen
Reply


Messages In This Thread
GPIO debounce not working - by Jewa_TWN - 06-23-2019, 07:16 AM
RE: GPIO debounce not working - by Tim Curtis - 06-23-2019, 12:55 PM
RE: GPIO debounce not working - by Jewa_TWN - 06-24-2019, 07:12 AM
RE: GPIO debounce not working - by Tim Curtis - 06-24-2019, 01:20 PM
RE: GPIO debounce not working - by Jewa_TWN - 06-25-2019, 08:19 AM
RE: GPIO debounce not working - by Jewa_TWN - 06-29-2019, 09:12 AM
RE: GPIO debounce not working - by Jewa_TWN - 07-20-2019, 09:39 AM

Forum Jump: