01-20-2021, 12:36 AM
@ Tim and others - clean USB output V/A settings possible?
I wonder, if there is a way to change the voltage/milli-amp of the 5V of the clean USB out ?
Is there a kind of low/high setting possible in the OS?
After having occasionally a loss of USB connection to my Chord Mojo DAC (which I described earlier) and getting a kind of "white noise" I have tested the connection from the Allo USBridge Sig. via my JCAT USB cable into my Intona USB Isolator to a RME ADI2 DAC.
I do not get a sync and signal at all, when the Intona Isolator is in between. Without the Intona they connect fine.
The Intona USB Isolator sepcs are:
Input voltage max=6V, min=4,5V
current consumption = 140mA
Output voltage max=5V, min 4,5V
Output current nom. 300mA, max 500mA, efficiency 90%
Based on that experience I assume the output of the Allo USBridge Sig clean USB port is a bit weak.
When I use my MacBookPro instead of the Allo I do not have this problem.
Thx.
I wonder, if there is a way to change the voltage/milli-amp of the 5V of the clean USB out ?
Is there a kind of low/high setting possible in the OS?
After having occasionally a loss of USB connection to my Chord Mojo DAC (which I described earlier) and getting a kind of "white noise" I have tested the connection from the Allo USBridge Sig. via my JCAT USB cable into my Intona USB Isolator to a RME ADI2 DAC.
I do not get a sync and signal at all, when the Intona Isolator is in between. Without the Intona they connect fine.
The Intona USB Isolator sepcs are:
Input voltage max=6V, min=4,5V
current consumption = 140mA
Output voltage max=5V, min 4,5V
Output current nom. 300mA, max 500mA, efficiency 90%
Based on that experience I assume the output of the Allo USBridge Sig clean USB port is a bit weak.
When I use my MacBookPro instead of the Allo I do not have this problem.
Thx.