Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


Problem: Moode 6.4.2 and Airplay on USB Dac
#1
Hello,
I have installed Moode 6.4.2 in replacement of Moode 5.3 on a raspberry 3B+ connected on USB on an Chord Hugo2 DAC.
Impossible to have it working on Airplay. It fails completly.
I have reflashed a new SD card with the same version (6.4.2), same configuration but the same problem.

I flash it back to Moode 5.3 and all was working properly in this version.
I think there is a bug into the 6.4.2.

Can you confirm and let me know?
Reply
#2
When you say "Impossible to have it working on Airplay. It fails completly." what evidence can you provide that shows the failure?

For example:

1. Post any on-screen error messages that you see.
2. Reboot then post the MOODE Startup log

Code:
moodeutl -l
Enjoy the Music!
moodeaudio.org | Mastodon Feed | GitHub
Reply
#3
Oops replied to spam
Reply
#4
That post by ustvnow was flagged as SPAM.
Enjoy the Music!
moodeaudio.org | Mastodon Feed | GitHub
Reply
#5
By failing, it means that there is no sound produced on Airplay. No problem on UPNP.
I did the exact  same configuration on version 5.3 and I'm not getting any problem. It works like a charm on this version 5.3 with all protocols (Airplay, UPNP).
There is no visible failure on the screen... just no sound. I did it twice (Flash SD card from a fresh downloaded version 6.4.2) just to confirm I'm getting the same issue.
I will try to get the logs you've mentioned....
Reply
#6
Ok here is what I got for: moodeutl -l
20200412 143626 worker: -- Start
20200412 143626 worker: Successfully daemonized
20200412 143626 worker: Integrity check (passed)
20200412 143626 worker: Session loaded
20200412 143626 worker: Debug logging (off)
20200412 143626 worker: Device raw: (0:ALSA|1:Hugo2|i2s:none)
20200412 143626 worker: Device cfg: (USB audio device|1|1|PCM|0)
20200412 143626 worker: ALSA volume set to (0%)
20200412 143627 worker: -- System
20200412 143629 worker: Host name (moode)
20200412 143629 worker: moOde release (6.4.2 2020-02-12)
20200412 143629 worker: Raspbian OS (10.2)
20200412 143629 worker: Linux kernel (4.19.97-v7+ #1293)
20200412 143629 worker: Platform (Pi-3B 1GB v1.2)
20200412 143629 worker: Architecture (armv7l)
20200412 143629 worker: MPD version (0.21.16)
20200412 143629 worker: CPU governor (ondemand)
20200412 143629 worker: USB boot enabled
20200412 143629 worker: File system not expanded yet
20200412 143629 worker: HDMI port on
20200412 143630 worker: File check (OK)
20200412 143630 worker: -- Network
20200412 143630 worker: eth0 exists
20200412 143630 worker: IP addr (192.168.10.224)
20200412 143630 worker: Netmask (255.255.255.0)
20200412 143630 worker: Gateway (192.168.10.1)
20200412 143631 worker: Pri DNS (192.168.10.1)
20200412 143631 worker: Domain (None)
20200412 143631 worker: wlan0 exists
20200412 143631 worker: wifi country (US)
20200412 143631 worker: wlan0 SSID is blank
20200412 143631 worker: eth0 addr exists, AP mode not started
20200412 143631 worker: wlan0 address not assigned
20200412 143631 worker: -- Audio
20200412 143631 worker: ALSA outputs unmuted
20200412 143631 worker: ALSA card number (1)
20200412 143631 worker: Audio output (USB audio device)
20200412 143631 worker: Audio formats (S32_LE)
20200412 143631 worker: ALSA mixer name (PCM)
20200412 143631 worker: MPD volume control (software)
20200412 143631 worker: Hdwr volume controller exists
20200412 143631 worker: Max ALSA volume (100%)
20200412 143631 worker: -- Services
20200412 143631 worker: Reset renderer active state
20200412 143632 worker: MPD conf updated
20200412 143632 worker: MPD started
20200412 143633 worker: MPD accepting connections
20200412 143633 worker: Configure MPD outputs
20200412 143633 worker: MPD output 1 ALSA default (on)
20200412 143633 worker: MPD output 2 ALSA crossfeed (off)
20200412 143633 worker: MPD output 3 ALSA parametric eq (off)
20200412 143633 worker: MPD output 4 ALSA graphic eq (off)
20200412 143633 worker: MPD output 5 ALSA polarity inversion (off)
20200412 143633 worker: MPD output 6 ALSA bluetooth (off)
20200412 143633 worker: MPD output 7 HTTP stream (off)
20200412 143633 worker: MPD crossfade (off)
20200412 143633 worker: Audio source (Local)
20200412 143633 worker: Output device (Local)
20200412 143633 worker: Airplay receiver started
20200412 143633 worker: UPnP renderer started
20200412 143633 worker: USB auto-mounter (udisks-glue)
20200412 143633 worker: -- Music sources
20200412 143633 worker: USB sources (none attached)
20200412 143633 worker: NAS and UPnP sources (none configured)
20200412 143633 worker: -- Miscellaneous
20200412 143633 worker: Saved MPD vol level (0)
20200412 143633 worker: Preamp volume level (0)
20200412 143633 worker: MPD volume level (0) restored
20200412 143633 worker: ALSA volume level (100%)
20200412 143633 worker: Auto-play (Off)
20200412 143633 worker: Auto-shuffle service (Off)
20200412 143633 worker: Maintenance interval (3 hrs)
20200412 143633 worker: Screen saver activation (Never)
20200412 143633 worker: Session permissions (OK)
20200412 143633 worker: Watchdog started
20200412 143633 worker: Ready
20200412 144153 worker: Job shellinabox
Reply
#7
One additional stuff: as soon I try in Airplay, no more renderer are working anymore (UPNP), when I start to play, it switch automatically in pause. I have to reboot completly the Raspberry to be able to use it in UPNP.
my UPNP application is mConnect, using Qobuz.
Reply
#8
20200412 143631 worker: ALSA card number (1)
20200412 143631 worker: Audio output (USB audio device)
20200412 143631 worker: Audio formats (S32_LE)

In Airplay Config try setting Bit depth to 32-bit.
Enjoy the Music!
moodeaudio.org | Mastodon Feed | GitHub
Reply


Forum Jump: