Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


Power options for RPi + Allo BOSS v1.2
#10
(06-13-2018, 09:38 PM)Tim Curtis Wrote: Hi William,

I run my Piano 2.1 config with 2 x 5V feeds from an Anker battery similar to #5. The power sequence I use is below.

Powering down

Perform Menu, Restart, Shutdown and wait for the green activityr LED on the Pi to blink 10 times indicating the shutdown sequence is complete and power can safely be disconnected.

1. Disconnect power from the Pi
2. Disconnect power from the DAC

Powering up

1. Connect power to the DAC
2. Connect power to the Pi

Hello Tim

I want to develop a shunt regulated power supply (at least for my Allo Boss dac), and I would like to automate the power up (and down).
How much time does it take to turn on the raspberry after the dac ?
Reply


Messages In This Thread
RE: Power options for RPi + Allo BOSS v1.2 - by yannig - 10-25-2018, 10:25 AM

Forum Jump: