Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


Problem: USB DAC working only in two ports
#7
@andybri

I didn't recognize this DAC so as is my wont I hit the InterWeb™. Have you read the AudioScienceReview report on the SMSL Sanskrit 10th DAC? Did you notice this line at the end of amir's rather negative remarks?

Quote:EDIT: with input from SMSL engineers, the USB port is under powered. Using an external power supply restores full performance. 

I don't know if your model is the same or similar, but have you tried an external power supply? Granted, amir is talking about the effect of poor power on the performance of the DAC but the behavior of the USB interface itself could be affected as well.

If that doesn't do it, and you've already tried @CallMeMike's suggestions, then perhaps you should kick this issue to the Raspberry Pi forums where the RPi hardware/firmware/software folk hang out.

Regards,
Kent
Reply


Messages In This Thread
USB DAC working only in two ports - by andybri - 05-15-2020, 01:45 PM
RE: USB DAC working only in two ports - by TheOldPresbyope - 05-16-2020, 11:52 AM

Forum Jump: