Thank you for your donation!


Problem: MoodeAudio crashes when enabling bluetooth (RPi4 B+)
#1
Thumbs Up 
Hello

Whenever I enable Bluetooth on Moodeaudio on my RaspBerry Pi 4B+, Moodeaudio stops and is not reachable anymore. The pi is still reachable over SSH.

This used to work back with moodeaudio 4. The pi has Bluetooth built in, so I don't see what the problem could be...

Thanks for any pointers!

Stefan
Reply
#2
(01-19-2021, 07:25 AM)steeflemmens Wrote: Hello

Whenever I enable Bluetooth on Moodeaudio on my RaspBerry Pi 4B+, Moodeaudio stops and is not reachable anymore. The pi is still reachable over SSH.

This used to work back with moodeaudio 4. The pi has Bluetooth built in, so I don't see what the problem could be...

Thanks for any pointers!

Stefan

It might be that Moode 7.0.1 has not been updated to include the correct identification of the RPi 4B+ board yet. I had an issue with my USB DAC not working. Plus I noticed a few other things like WiFi or BT not be able to chosen in Moode and I could not install the 64-bit experimental version of Moode.

Tim told me that in 7.1 these things would be updated. Again, IDK, if that is your problem. But I figure I'd offer that the RPi 4 acts a little weird with the GUI.
Reply
#3
I'm not aware of an RPi 4 Model " B+". I think the "+" is bogus. From time to time the RPF has issued new revisions of the RPi 4 board (see revision codes).

What does System Info say for your setup? (either moodeutl -s from the command line or m>System info from the Sys Config panel in the moOdeUI)

Here's the head stanza for one of my players

Code:
pi@moode:/var/www/inc $ moodeutl -s|more
Generating info...

S Y S T E M   P A R A M E T E R S

moOde release        = 7.0.1 2020-12-23
RaspiOS            = 10.6
Linux kernel        = 5.4.77-v7l+ #1371
Platform        = Pi-4B 1GB v1.1
Architecture        = armv7l (32-bit)
System uptime        = up 22 hours, 11 minutes
Timezone        = America/New_York
Current time        = 2021-01-20 11:27:45


If the "Platform" line is empty then moOde didn't recognize your board because its revision code is newer than the list stored in moOde. That's what Tim is adjusting for the next release.

There is no change in any of the routines, however, so it's a simple addition to the list.

Regards,
Kent
Reply


Forum Jump: