ProtoDAC TDA1387 X8 project - Printable Version +- Moode Forum (https://moodeaudio.org/forum) +-- Forum: Audiophile (https://moodeaudio.org/forum/forumdisplay.php?fid=32) +--- Forum: Audio gear (https://moodeaudio.org/forum/forumdisplay.php?fid=10) +--- Thread: ProtoDAC TDA1387 X8 project (/showthread.php?tid=5531) |
RE: ProtoDAC TDA1387 X8 project - the_bertrum - 09-21-2023 (09-21-2023, 06:35 AM)DRONE7 Wrote:(09-21-2023, 12:16 AM)Tim Curtis Wrote:(09-20-2023, 09:17 PM)Ludomaniac Wrote: Good evening great people I hope you used Jersey Royals, they give a much more open sound stage I find. I tried Maris Piper once, but the bass went all muddy. RE: ProtoDAC TDA1387 X8 project - DRONE7 - 09-21-2023 (09-21-2023, 06:46 AM)the_bertrum Wrote:You mustn't M.A.S.H the Maris Piper (he gets a little annoyed and it interferes with the operation of his big drone)(09-21-2023, 06:35 AM)DRONE7 Wrote:(09-21-2023, 12:16 AM)Tim Curtis Wrote:(09-20-2023, 09:17 PM)Ludomaniac Wrote: Good evening great people https://www.audiokarma.org/forums/index.php?threads/technics-m-a-s-h-how-does-it-work.623525/ https://www.gannawaynz.co.nz/bagpipes-bands/reeds/drone-reeds?product_id=990 RE: ProtoDAC TDA1387 X8 project - Tim Curtis - 09-21-2023 (09-21-2023, 06:35 AM)DRONE7 Wrote:(09-21-2023, 12:16 AM)Tim Curtis Wrote:(09-20-2023, 09:17 PM)Ludomaniac Wrote: Good evening great people lol, I need one of those an AI spell correctors. RE: ProtoDAC TDA1387 X8 project - Edzacc - 09-25-2023 Hello Thank you for your replies I did also find a similar hat amp for the Rpi following your suggestions. The IQaudIO Pi-AMP+ TPA3116 amplifier designs that stacks and back powers the DAC and PI. with 19.5V psu Although is it out of stock I did find one in the UK. It does the job of an all in one system ! Many thanks again RE: ProtoDAC TDA1387 X8 project - hifinet - 09-26-2023 Lucky you found one. The IQaudIO Pi-AMP+ appears to be a legacy product and is discontinued. RE: ProtoDAC TDA1387 X8 project - rh2018 - 09-26-2023 (09-26-2023, 12:25 AM)hifinet Wrote: Lucky you found one. The IQaudIO Pi-AMP+ appears to be a legacy product and is discontinued. IQAudio was aquired by Raspberry Pi Trading in 2020.The IQAudio HAT's are now available under the Raspberry Pi banner at very attractive prices. RE: ProtoDAC TDA1387 X8 project - the_bertrum - 09-26-2023 (09-26-2023, 07:42 AM)rh2018 Wrote:(09-26-2023, 12:25 AM)hifinet Wrote: Lucky you found one. The IQaudIO Pi-AMP+ appears to be a legacy product and is discontinued. https://www.raspberrypi.com/products/digiamp-plus/ RE: ProtoDAC TDA1387 X8 project - hifinet - 09-26-2023 The IQaudIO Pi-AMP+ is discontinued. It was a traditional amplifier based on the TI TPA3116, accepting analog inputs. It is able to take the analog output from ProtoDAC. The IQaudIO DigiAMP+ is an integrated amplifier with a built in DAC, and does not accept analog inputs. So you are stuck with the inferior oversampling DAC. It is not able to take the analog output from ProtoDAC. RE: ProtoDAC TDA1387 X8 project - hifinet - 09-26-2023 The JustBoom Amp (last one from PiShop.us) is also a traditional amplifier that takes balanced or single ended analog inputs, and should work with ProtoDAC. RE: ProtoDAC TDA1387 X8 project - Edzacc - 09-27-2023 (09-26-2023, 03:58 PM)hifinet Wrote: The IQaudIO Pi-AMP+ is discontinued. It was a traditional amplifier based on the TI TPA3116, accepting analog inputs. It is able to take the analog output from ProtoDAC. Thank you for following up on this, regarding "It is able to take the analog output from ProtoDAC" are these available on the 40 pin GPIO header on the ProtoDAc (currently I am using the IQaudIO Pi-AMP+ with a hat IQ DAC which I'll swap with the ProtoDac when completed) Are GPIO pin designations standard for Rpi hats? Many thanks |