(04-23-2020, 08:34 PM)Morde Wrote: Hello Tim.

Will the parametric equalizer be active for the output when the analog input is chosen?

I’m trying to figure out a way to feed frequency sweep from my laptop from Room EQ Wizard to the RPi and then measure frequency response with my Umik-1 microphone.

Would be nice to able to verify the EQ adjustments by actually measuring it.

(12-26-2019, 11:59 PM)Humus Wrote:

(09-06-2019, 09:37 PM)Tim Curtis Wrote: The input is managed by the DAC. moOde just sends the command to switch the DAC to Analog input. I suppose moOde could poll for no audio output and then automatically swap from Analog-in back to Local output (MPD, renderers) but this is something that does not seem to be generally applicable. It would be up to user to do this coding.

Hi Tim,

I just acquired said DAC because I want to be able to connect my TV to the line-in, connect my amp to the RCA.
What I want to achieve is: Set the "source select" of moOde to "analogue input" as default so the TV is running in pass-through to my amp.
As soon as I connect to the Spotify Connect service and start playing a song ==> switch source to Local (MPD)
As soon as I stop the song or disconnect from the Spotify Connect service ==> switch source back to "analogue input"

Same for airplay, same for radio, same for basically all moOde playback functions

If I understand correct there are pre- post scripts for Spotify and Airplay (spotevent.sh  spspost.sh  spspre.sh). So I reckon I could use these to switch the source select from local MPD to analoge input.

However I have no idea how to actualy send the command to the DAC to do the actual switching. How did you manage to achieve this? Or what should I invoke to do the switching? 

(and the above would solve the problem for spotify and airplay, but not for all the other functionality :'( 

Thanks a lot for helping a total noob out here! (Or point me in the right direction)