NanoSound DAC Pro anyone? - Printable Version +- Moode Forum (https://moodeaudio.org/forum) +-- Forum: Community (https://moodeaudio.org/forum/forumdisplay.php?fid=18) +--- Forum: General Discussion (https://moodeaudio.org/forum/forumdisplay.php?fid=21) +--- Thread: NanoSound DAC Pro anyone? (/showthread.php?tid=219)

NanoSound DAC Pro anyone? - TheOldPresbyope - 06-01-2018 Perhaps others already know of it but new to me is the NanoSound DAC Pro. https://nanomesher.com/store/NanoSound-DAC-Pro-for-Raspberry-Pi-p90621094 This is a RPi HAT with the following claimed specs: Texas Instruments PCM5122 DAC 192kHz Sampling Rate / 24bit Resolution Burr-Brown DAC for best sound quality Hardware volume control for best quality using “alsamixer” Texas Instruments TPS7A4700 Ultra Low Noise Voltage Regulator 1.3" High Resolution OLED Display Switchable Power Option Power from a single microUSB port or independently Raspberry Pi Power switch Turn on and Gracefully shut down Raspberry Pi System 6 GPIO buttons for Media Control Infrared Receiver and Remote Control (LIRC compatible) Works with all Raspberry Pi with 40pin Header (Including Pi 3 Model B+, Pi 3 Model B , Pi 2 Model B, Pi 1 B+) It's being mentioned specifically with respect to Volumio but I see no reason a priori why it would not work equally well with moOde if it works at all. So far, I have found only fluff pieces about it; no hardcore audiophile assessment. Anyone here try it yet? Regards, Kent