[PROBLEM] No volume control over Bluetooth - Printable Version +- Moode Forum (https://moodeaudio.org/forum) +-- Forum: moOde audio player (https://moodeaudio.org/forum/forumdisplay.php?fid=3) +--- Forum: Support (https://moodeaudio.org/forum/forumdisplay.php?fid=7) +--- Thread: [PROBLEM] No volume control over Bluetooth (/showthread.php?tid=3675) |
No volume control over Bluetooth - BitCoder - 04-04-2021 Hello Tim I installed version 7.1.0 yesterday. For me, it is the best working version so far. But there is one point that is not usable to me. I have a turntable connected via Bluetooth. Unfortunately, the volume cannot be adjusted in that mode, or I don't know-how. I am using the HIFIBerry Amp2 hat. Therefore there is no volume control via potentiometer. Do you have any suggestions or ideas? RE: No volume control over Bluetooth - Tim Curtis - 04-04-2021 moOde's Bluetooth receiver function assumes the client (Smartphone, Tablet, etc) is responsible for controlling volume. I think Bluetooth turntables assume the receiver controls volume as would be the case for Bluetooth speakers. Bluetooth receiver volume could prolly be added to moOde but it's not a trivial amount of work and so there would need to be some amount of demand for this to get it on the TODO list. RE: No volume control over Bluetooth - BitCoder - 04-07-2021 Thanks, Tim, for the quick answer. That means I have to go back to the old times and use an ordinary analog amplifier for the turntable. RE: No volume control over Bluetooth - TheOldPresbyope - 04-07-2021 (04-07-2021, 03:00 PM)BitCoder Wrote: Thanks, Tim, for the quick answer. That means I have to go back to the old times and use an ordinary analog amplifier for the turntable. If it's just the lack of a physical volume control that is troubling you, then why not get a self-contained, USB-interfaced volume-control knob? One such example is the Drok that I use but there are others. These devices have been supported in moOde for some time. Look under Volume options in the Audio Config panel. Regards, Kent RE: No volume control over Bluetooth - BitCoder - 08-22-2021 I am coming back to this subject. After a long time, I have got the time to test a USB volume control as suggested. In general, it does work. But there is a problem when switching from the ordinary to the Bluetooth source. The volume changes to 100% for a short period. If the Bluetooth source already sends music, then you will be startled, and the loudspeaker might be damaged too. Is there a way that the volume is set to 0% while switching the sources until the USB volume control is reread? RE: No volume control over Bluetooth - Tim Curtis - 08-22-2021 USB volume control is only for MPD. Volume for a Bluetooth source is always set by the source. Set the source volume to 0 before connecting. |