![]() |
Suptronics X400? - Printable Version +- Moode Forum (https://moodeaudio.org/forum) +-- Forum: moOde audio player (https://moodeaudio.org/forum/forumdisplay.php?fid=3) +--- Forum: Support (https://moodeaudio.org/forum/forumdisplay.php?fid=7) +--- Thread: Suptronics X400? (/showthread.php?tid=3765) |
Suptronics X400? - clintla - 05-02-2021 UPDATED So could not get this one working w/ Volumio, Was getting File not found when selecting music file. loaded up the current version of Moode got it all configured Now trying w/ Moode & when I have the DAC setup as Suptronics X400 and when I choose a radio station.. I get "ailed to open "ALSA Default" (alsa); Failed to open ALSA device "_audioout": No such file or directory " I get theThink this is just a problem DAC. Any suggestions before I just unload these DACs? RE: Suptronics X400? - clintla - 05-02-2021 Exact Error MPD error Failed to open "ALSA Default" (alsa); Failed to open ALSA device "_audioout": No such file or directory RE: Suptronics X400? - jonners - 05-02-2021 Try selecting HifiBerry DAC as the I2S audio device. RE: Suptronics X400? - clintla - 05-02-2021 (05-02-2021, 07:14 PM)jonners Wrote: Try selecting HifiBerry DAC as the I2S audio device. Do you mean "Named Device" under configure? if not, what do you mean by I2S audio device? I tried HifiBerry DAC under named device with the same error the suptronics support site say to try http://www.suptronics.com/miniPCkits/x400-v3.0-software.html 3. Within the Audio section select the device you have (such as Pi-DAC+) and press SET Pi-DAC+ isnt listed but IQaudio Pi-DAC+ is listed but it has the same issue. RE: Suptronics X400? - clintla - 05-02-2021 Shouldn't be this hard right? Tried multi RP3's and a RP4. None worked Tried Volumio, Moode & Runadio. None worked I got Geekworm to send another unit & tried all over again. None worked Now trying multi different Named Devices under DAC for Moode. None worked all get similar errors that device/file not found. RE: Suptronics X400? - jonners - 05-02-2021 After selecting the X400 in the list do you see a message telling you to reboot? RE: Suptronics X400? - Tim Curtis - 05-02-2021 Reboot then post Moode startup log. Code: moodeutl -l RE: Suptronics X400? - clintla - 05-02-2021 (05-02-2021, 08:35 PM)jonners Wrote: After selecting the X400 in the list do you see a message telling you to reboot? Yes, I'm rebooting after every try, before I try, I go back to M->configure->audio & then check the named devices. this time also going to the SDCARD to play the audio file test & it gets the same error as trying a radio station RE: Suptronics X400? - clintla - 05-02-2021 (05-02-2021, 08:36 PM)Tim Curtis Wrote: Reboot then post Moode startup log. pi@moode:~ $ moodeutl -l 20210502 160935 worker: -- Start 20210502 160935 worker: Successfully daemonized 20210502 160936 worker: Integrity check (passed) 20210502 160937 worker: File check (OK) 20210502 160938 worker: Session vacuumed 20210502 160938 worker: Session loaded 20210502 160938 worker: Debug logging (OFF) 20210502 160938 worker: -- Audio debug 20210502 160938 worker: ALSA cards: (0:empty | 1:empty | 2:empty | 3:empty 20210502 160938 worker: MPD config: (0:HiFiBerry DAC+ | mixer ![]() 20210502 160938 worker: ALSA mixer actual (Digital) 20210502 160938 worker: ALSA Digital volume set to (Invalid card number.) 20210502 160938 worker: -- System 20210502 160941 worker: Host (moode) 20210502 160941 worker: moOde (7.2.0 2021-04-24) 20210502 160941 worker: RaspiOS (10.6) 20210502 160941 worker: Kernel (5.4.77-v7+ #1371) 20210502 160941 worker: Platform (Pi-3B 1.2 1GB) 20210502 160941 worker: ARM arch (armv7l, 32-bit kernel) 20210502 160941 worker: MPD ver (0.22.6_p0x3) 20210502 160941 worker: CPU gov (ondemand) 20210502 160942 worker: USB boot not enabled yet 20210502 160942 worker: File system expanded 20210502 160942 worker: HDMI port on 20210502 160942 worker: -- Network 20210502 160942 worker: eth0 exists 20210502 160942 worker: eth0 wait 0 for IP address 20210502 160945 worker: eth0 wait 1 for IP address 20210502 160948 worker: eth0 wait 2 for IP address 20210502 160951 worker: eth0 wait 3 for IP address 20210502 160954 worker: eth0 wait 4 for IP address 20210502 161009 worker: eth0 address not assigned 20210502 161009 worker: wlan0 exists 20210502 161009 worker: wifi country (US) 20210502 161009 worker: wlan0 trying SSID (Springfield3) 20210502 161009 worker: IP addr (10.0.0.249) 20210502 161009 worker: Netmask (255.255.255.0) 20210502 161009 worker: Gateway (10.0.0.1) 20210502 161009 worker: Pri DNS (10.0.0.1) 20210502 161009 worker: Domain (None) 20210502 161009 worker: Pi integrated wlan0 power save disabled 20210502 161009 worker: -- Audio config 20210502 161010 worker: MPD conf updated 20210502 161010 worker: ALSA card number (0) 20210502 161010 worker: MPD audio output (HiFiBerry DAC+) 20210502 161010 worker: WARNING: No device found at MPD configured card 0 20210502 161010 worker: ALSA mixer name (Digital) 20210502 161010 worker: MPD volume control (software) 20210502 161010 worker: Hdwr volume controller exists 20210502 161010 worker: Max ALSA volume (100%) 20210502 161010 worker: ALSA loopback (Off) 20210502 161010 worker: Reset renderer active flags 20210502 161010 worker: CamillaDSP (off) 20210502 161010 worker: -- MPD startup 20210502 161010 worker: MPD started 20210502 161011 worker: MPD accepting connections 20210502 161011 worker: MPD output 1 ALSA Default (on) 20210502 161011 worker: MPD output 2 ALSA Bluetooth (off) 20210502 161011 worker: MPD output 3 HTTP Server (off) 20210502 161011 worker: MPD crossfade (off) 20210502 161011 worker: MPD ignore CUE files (yes) 20210502 161011 worker: -- Feature availability 20210502 161011 worker: Source select (available) 20210502 161011 worker: Source select (source: MPD) 20210502 161011 worker: Source select (output: HiFiBerry DAC+) 20210502 161017 worker: Bluetooth (available: started) 20210502 161017 worker: Airplay renderer (available) 20210502 161017 worker: Spotify renderer (available) 20210502 161017 worker: Squeezelite (available) 20210502 161017 worker: RoonBridge renderer (not installed) 20210502 161017 worker: UPnP renderer (available) 20210502 161017 worker: DLNA server (available) 20210502 161017 worker: UPnP browser (available) 20210502 161017 worker: GPIO button handler (available) 20210502 161017 worker: Stream recorder (n/a) 20210502 161017 worker: -- Music sources 20210502 161017 worker: USB sources (none attached) 20210502 161017 worker: NAS and UPnP sources (none configured) 20210502 161017 worker: -- Other 20210502 161017 worker: USB volume knob (Off) 20210502 161017 worker: Shellinabox SSH started 20210502 161017 worker: USB auto-mounter (udisks-glue) 20210502 161017 worker: LED0 (On) 20210502 161017 worker: LED1 (On) 20210502 161017 worker: Saved MPD vol level (0) 20210502 161017 worker: Preamp volume level (0) 20210502 161017 worker: MPD volume level (0) restored 20210502 161017 worker: ALSA Digital volume (Invalid card number.) 20210502 161017 worker: Auto-play (Off) 20210502 161017 worker: Maintenance interval (3 hours) 20210502 161017 worker: Screen saver activation (Never) 20210502 161017 worker: Session permissions (OK) 20210502 161017 worker: Watchdog started 20210502 161017 worker: Ready RE: Suptronics X400? - jonners - 05-02-2021 You selected HifiBerry DAC+. What if you select Suptronics x400? |