Moode Forum
[PROBLEM] Turning parametric equalizer off/on - Printable Version

+- Moode Forum (https://moodeaudio.org/forum)
+-- Forum: moOde audio player (https://moodeaudio.org/forum/forumdisplay.php?fid=3)
+--- Forum: Support (https://moodeaudio.org/forum/forumdisplay.php?fid=7)
+--- Thread: [PROBLEM] Turning parametric equalizer off/on (/showthread.php?tid=4180)



Turning parametric equalizer off/on - PERRLA - 09-02-2021

Should the changes to the peq take effect after "saving" or perhaps I'm doing something wrong?  In order for my changes to take effect I must go back to the configure audio page, turn peq off ---set, then select "default" then set again.

My version is 6.7.1


RE: Turning parametric equalizer off/on - Sehnsucht - 09-03-2021

(09-02-2021, 08:36 PM)PERRLA Wrote: Should the changes to the peq take effect after "saving" or perhaps I'm doing something wrong?  In order for my changes to take effect I must go back to the configure audio page, turn peq off ---set, then select "default" then set again.

My version is 6.7.1

I'm on 7.3 and my changes are applied after I click save.


RE: Turning parametric equalizer off/on - PERRLA - 09-03-2021

(09-03-2021, 12:12 PM)Sehnsucht Wrote:
(09-02-2021, 08:36 PM)PERRLA Wrote: Should the changes to the peq take effect after "saving" or perhaps I'm doing something wrong?  In order for my changes to take effect I must go back to the configure audio page, turn peq off ---set, then select "default" then set again.

My version is 6.7.1

I'm on 7.3 and my changes are applied after I click save.
Thanks, I'll update and give it a try.  Also is the process to update the same as if I were setting up the device from the beginning.  I don't see an "update" button.


RE: Turning parametric equalizer off/on - Sehnsucht - 09-03-2021

This is the first version I've used. But I can click the m on the top right, configure, system, check for software update.


RE: Turning parametric equalizer off/on - the_bertrum - 09-03-2021

V6 to V7 isn't an automatic update I'm afraid. You need to download a fresh image and then reconfigure from scratch.