[PROBLEM] CM4 to CM3 adapter ALSA trouble - Printable Version +- Moode Forum (https://moodeaudio.org/forum) +-- Forum: moOde audio player (https://moodeaudio.org/forum/forumdisplay.php?fid=3) +--- Forum: Support (https://moodeaudio.org/forum/forumdisplay.php?fid=7) +--- Thread: [PROBLEM] CM4 to CM3 adapter ALSA trouble (/showthread.php?tid=4367)

CM4 to CM3 adapter ALSA trouble - pkdick - 10-19-2021 Hello everyone, I recently bought a Raspberry CM4 lite module and  a CM4 to CM3 adapter to replace my CM3 lite module on my USBBridge Signature (as I read in the audiophile forum that it was possible to do it cf. https://audiophilestyle.com/forums/topic/57258-allo-usbridge-signature/page/49/) . I had to add the following lines in my config.txt to get Moode boot and network access: dtoverlay= noeth (it was necessary to add noeth.dtbo to the overlay repertory), otg_mode=1 Then Moode appeared on the display that I connected to the USBBridge. Since then I did many trials without success as it seemed that ALSA could not initiate (my I2S KATANA DAC was not recognized): I found on the forum that such failure was already recorded for different reasons but no real fix (I assume that it is mainly a software/firmware issue, as everything works OK with the CM3 Lite module). I would be grateful if someone could give me a piece of advice to work out this issue. Best regards,