+- Moode Forum (https://moodeaudio.org/forum)
+-- Forum: moOde audio player (https://moodeaudio.org/forum/forumdisplay.php?fid=3)
+--- Forum: Support (https://moodeaudio.org/forum/forumdisplay.php?fid=7)
+--- Thread: [PROBLEM] Moode 9.0.1 no streaming radio if ETH is set to DHCP (/showthread.php?tid=6572)
[PROBLEM] Moode 9.0.1 no streaming radio if ETH is set to DHCP - marco.mosca - 06-06-2024
I'm experiencing a strange situation. Radio streaming works only if moode is connected through WIFI or through ETH with an IP static address set.
When on ETH DHCP I get the following error: "Failed to decode http://onair11.xdevel.com:8024; CURL failed: Failed to connect to onair11.xdevel.com port 8024 after 2 ms: Couldn't connect to server"
While using the ETH DHCP I have this strange situation (moodeutl output) despite I'am connected via ssh from my computer:
20240606 183413 worker: --
20240606 183413 worker: -- Start moOde 9 series
20240606 183413 worker: --
20240606 183413 worker: Successfully daemonized
20240606 183413 worker: Wait for Linux startup
20240606 183419 worker: Linux startup complete
20240606 183419 worker: Boot config is ok
20240606 183419 worker: Session loaded
20240606 183421 worker: Package locks applied
20240606 183422 worker: File check complete
20240606 183422 worker: Debug logging off
20240606 183422 worker: --
20240606 183422 worker: -- System
20240606 183422 worker: --
20240606 183423 worker: Host name: pCP2GB
20240606 183423 worker: RPi model: Pi-4B 1.5 2GB
20240606 183423 worker: moOde release: 9.0.1 2024-05-30
20240606 183423 worker: RaspiOS: 12.5 Bookworm 64-bit
20240606 183423 worker: Linux Kernel: 6.6.28 64-bit
20240606 183423 worker: MPD version: 0.23.14
20240606 183423 worker: User id: mda
20240606 183423 worker: Home folder: /home/mda
20240606 183423 worker: Time zone: Europe/Rome
20240606 183423 worker: Kbd layout: lt
20240606 183423 worker: HDMI ports(s): on
20240606 183423 worker: Sys LED0: on
20240606 183423 worker: Sys LED1: on
20240606 183423 worker: Reduce power: n/a
20240606 183423 worker: CPU governor: ondemand
20240606 183423 worker: Integ audio: vc4-kms-v3d
20240606 183423 worker: --
20240606 183423 worker: -- Network
20240606 183423 worker: --
20240606 183423 worker: Eth0
20240606 183423 worker: Ethernet: adapter exists
20240606 183423 worker: Ethernet: timeout off
20240606 183423 worker: Ethernet: address not assigned
20240606 183423 worker: Wlan0
20240606 183423 worker: Wireless: adapter does not exist
20240606 183423 worker: No active network interface
20240606 183423 worker: --
20240606 183423 worker: -- File sharing
20240606 183423 worker: --
20240606 183423 worker: SMB file sharing: off
20240606 183423 worker: NFS file sharing: off
20240606 183423 worker: DLNA file sharing: off
Attached is the NW config page.
Thanks.
Ciao.
Marco
RE: Moode 9.0.1 no streaming radio if ETH is set to DHCP - Tim Curtis - 06-06-2024
The log entry below indicates Linux did not receiver an IP address from your Router
20240606 183423 worker: Ethernet: address not assigned
Check your Router DHCP config
Try rebooting your Router.
RE: Moode 9.0.1 no streaming radio if ETH is set to DHCP - marco.mosca - 06-07-2024
(06-06-2024, 10:00 PM)Tim Curtis Wrote: The log entry below indicates Linux did not receiver an IP address from your Router
20240606 183423 worker: Ethernet: address not assigned
Check your Router DHCP config
Try rebooting your Router.
Tim,
thanks for your answer. I am connected to moode via ssh: how is it possible?
Moreover if I check the router attached devices I see the raspi with its ip (the same that I use to connect via ssh).
Also, please look to the screenshot attached to the first post. It shows that neither ETH nor WIFI are connected. Sounds weird.
Marco