Hi all
I just built a new box with a Pi4B, a new IQ Audio Pi DigiAmp+ (the one with the green plugs for speaker lead connection, not the on-board screw block) the latest 701 release, and I'm having a few issues.
The main one is that Airplay volume doesn't work from my Mac - If I connect to Airplay, I can play back, but the volume is as it was before I connected - I can't adjust the volume from the Mac. And once I connect, the 'Airplay active' page is shown, so I can't change the volume with the main page slider.
The Mac volume control does work to turn the volume up and down within the level already set (20% in this case) but I can't go higher than the 20%.
I've tried it with both hardware and software control (the DigiAmp has hardware control built in) but no difference in operation.
I'm happy my networking is fine - Gigabit Cisco business L3 switch. All other devices are off - hdmi, wifi, bluetooth.
It's been a while, but I'm pretty sure I covered all the config bases.
EDIT: Belay that - it's the app (Plex). iTunes adjusts volume normally.
I just built a new box with a Pi4B, a new IQ Audio Pi DigiAmp+ (the one with the green plugs for speaker lead connection, not the on-board screw block) the latest 701 release, and I'm having a few issues.
The main one is that Airplay volume doesn't work from my Mac - If I connect to Airplay, I can play back, but the volume is as it was before I connected - I can't adjust the volume from the Mac. And once I connect, the 'Airplay active' page is shown, so I can't change the volume with the main page slider.
The Mac volume control does work to turn the volume up and down within the level already set (20% in this case) but I can't go higher than the 20%.
I've tried it with both hardware and software control (the DigiAmp has hardware control built in) but no difference in operation.
I'm happy my networking is fine - Gigabit Cisco business L3 switch. All other devices are off - hdmi, wifi, bluetooth.
It's been a while, but I'm pretty sure I covered all the config bases.
EDIT: Belay that - it's the app (Plex). iTunes adjusts volume normally.