02-08-2020, 08:51 PM
(This post was last modified: 02-08-2020, 09:15 PM by Norbert.
Edit Reason: command corrected
)
You can also use a regular mouse to do this.
When triggerhappy runs connect a mouse and then start
You can see which buttons triggerhappy recognizes and then enter the corresponding moode commands.
Supported are: wheel button, left and right mouse button, wheel (maybe for volume?) And the x / y coordinates.
Best regards
Norbert
When triggerhappy runs connect a mouse and then start
Code:
thd --dump /dev/input/event*You can see which buttons triggerhappy recognizes and then enter the corresponding moode commands.
Supported are: wheel button, left and right mouse button, wheel (maybe for volume?) And the x / y coordinates.
Best regards
Norbert
