Hi, first ever use of a rotary encoder.... connected 3.3v, GND, gpio 23, and 24.....
Config>audio> and set Rotary encoder to 'on'.... set MPD Config>volume control> software (sort of counter intuitive as an encoder is a hardware item..???? ......but only options are 'disabled' and 'software')
Encoder works but needs several turns (10+) to go from low to high.... which of the parameters in the settings box do I need to change and to what to get quicker control ?
The encoder has a push switch.... is there a gpio pin to connect to that will enable mute toggle with this ?
Thanks !
bob
Config>audio> and set Rotary encoder to 'on'.... set MPD Config>volume control> software (sort of counter intuitive as an encoder is a hardware item..???? ......but only options are 'disabled' and 'software')
Encoder works but needs several turns (10+) to go from low to high.... which of the parameters in the settings box do I need to change and to what to get quicker control ?
The encoder has a push switch.... is there a gpio pin to connect to that will enable mute toggle with this ?
Thanks !
bob
----------
bob
bob
