Hi,
Since version 4.1, I have a problem that music sometimes starts to hissing music. KALI reclocker starts blinking blue and red.
Three days back I started a new clean installation 4.2. Three days worked very well and yesterday morning after power on the RPI + 5 minutes of listening to music began to hissing again. In addition, the remote control stopped working (LIRC is working but irw cmd does not respond to the buttons on the remote control) and sometimes the dual mode does not work after the restart, the left channel is played.
Everything I did extra is installing a remote control via LIRC and a spotify connect.
I supply the RPI with a linear power supply. It delivers exactly 5V and the relay attenuator has only 4.8V but that should be enough. On version 4.0 I did not have similar problems on the same audio setup.
Does anyone have advice where can be a problem? Possible self-switching between 32bit and 24bit?
I apologize for my bad english
Thank you all
My setup: RPI3B+, Kali reclock, Piano 2.1 and relay attenuator, DIY linear power supply, Sox 32bit/ *khz
Since version 4.1, I have a problem that music sometimes starts to hissing music. KALI reclocker starts blinking blue and red.
Three days back I started a new clean installation 4.2. Three days worked very well and yesterday morning after power on the RPI + 5 minutes of listening to music began to hissing again. In addition, the remote control stopped working (LIRC is working but irw cmd does not respond to the buttons on the remote control) and sometimes the dual mode does not work after the restart, the left channel is played.
Everything I did extra is installing a remote control via LIRC and a spotify connect.
I supply the RPI with a linear power supply. It delivers exactly 5V and the relay attenuator has only 4.8V but that should be enough. On version 4.0 I did not have similar problems on the same audio setup.
Does anyone have advice where can be a problem? Possible self-switching between 32bit and 24bit?
I apologize for my bad english
Thank you all
My setup: RPI3B+, Kali reclock, Piano 2.1 and relay attenuator, DIY linear power supply, Sox 32bit/ *khz
