[PROBLEM] No EQ after upgrade to 4.3

[michaeleve]

Solved, sorta...

Couldn't leave it alone.
Started over again, Same image, new uSD card.
Booted, set Allo Boss
Had to move it so powered down.
Powered up and ran a test track. Sounds fine except EQ
...just like before.
Tried EQ first and still no "LoBoost+" Bummer
Shut it down.
Came back a little later because it occurred to me that
the EQ change had not triggered MPD Restart (putting the audio in 'pause')
The eg setting showed the same but still wasn't working
Set  'regular' eq to Off. This time the MPD reset happened.
Named, Configured and Apply and Set Parametric EQ and this time it worked!

What was different?
Sequence of boots. Which EQ was tried first. MP3 instead of OGG test file. Different SD card (the third)
Which of these, if any fixed the problem? Beats me. Insert quasi-religious speculation here.

Supposedly doing the same thing over and over and expecting a different result
is an indication of insanity. It's more like a required activity with computers.

Tim; is there some documentation on how to edit the  eqfa4p.conf to
produce a 'shelf' type result? It would be very useful to emulate baffle step correction (BSC) circuits.
Yes I understand it's not supported.

Thanks
Michael