10-16-2020, 03:54 AM
(This post was last modified: 10-16-2020, 04:09 AM by CallMeMike.)
1. Maybe your power supply is not up to the task (faulty or not fitting the power requirements for feeding the RPi3 + BOSS DAC)
2. Experiment with TWO power supplies connected separately to the RPi and the BOSS
On all set-ups you choose for supplying 5VDC to your RPi3 + BOSS DAC combo OBSERVE the guides:
- BOSS Setup Manual
- Boss 1.2 DAC Tech Manual
- BOSS 1.2 Power Feeding Instructions
The guides can be found here: https://allo.com/sparky/boss-dac.html#downloads
[edit] << After this the Moode is available but my NAS needs to be reconnected >>
Once the NAS is set-up in the MoOde config there should not be any need to reconnect the NAS. Please consider re-loading the current MoOde build on a known good uSD card, revise the MoOde Setup Guide, use only the LAN connection and do not attach any devices to the RPi (apart from the BOSS DAC) until you are satisfied with your power supply feed arrangements.
2. Experiment with TWO power supplies connected separately to the RPi and the BOSS
On all set-ups you choose for supplying 5VDC to your RPi3 + BOSS DAC combo OBSERVE the guides:
- BOSS Setup Manual
- Boss 1.2 DAC Tech Manual
- BOSS 1.2 Power Feeding Instructions
The guides can be found here: https://allo.com/sparky/boss-dac.html#downloads
[edit] << After this the Moode is available but my NAS needs to be reconnected >>
Once the NAS is set-up in the MoOde config there should not be any need to reconnect the NAS. Please consider re-loading the current MoOde build on a known good uSD card, revise the MoOde Setup Guide, use only the LAN connection and do not attach any devices to the RPi (apart from the BOSS DAC) until you are satisfied with your power supply feed arrangements.
