12-27-2020, 11:08 AM
(This post was last modified: 12-27-2020, 11:13 AM by jackobtone.)
Hello everyone!
Here is my bug:
Failed to open "ALSA default" (alsa);
Failed to open ALSA device "hw:0,0":
No such file or directory
Everything happens after editting the boot/config file and adding two lines that lirc needs:
disable_splash=1
disable_overscan=1
hdmi_drive=2
hdmi_blanking=1
hdmi_force_edid_audio=1
hdmi_force_hotplug=1
hdmi_group=0
dtparam=i2c_arm=on
dtparam=i2s=on
dtparam=audio=off
dtoverlay=i-sabre-q2m
#dtoverlay=disable-wifi
#dtoverlay=disable-bt
dtoverlay=gpio-poweroff,gpiopin=22,active_low
dtoverlay=gpio-shutdown,gpio_pin=17,active_low=0,gpio_pull=down
dtoverlay=gpio-ir
dtparam=gpio_in_pin=26
After removing them and rebooting everything works as it should. Again pasting them in and rebooting -> problem reappears.
My system was updated from 7.0.0 from the mOode position. Should I do a clear install?
Here is my bug:
Failed to open "ALSA default" (alsa);
Failed to open ALSA device "hw:0,0":
No such file or directory
Everything happens after editting the boot/config file and adding two lines that lirc needs:
disable_splash=1
disable_overscan=1
hdmi_drive=2
hdmi_blanking=1
hdmi_force_edid_audio=1
hdmi_force_hotplug=1
hdmi_group=0
dtparam=i2c_arm=on
dtparam=i2s=on
dtparam=audio=off
dtoverlay=i-sabre-q2m
#dtoverlay=disable-wifi
#dtoverlay=disable-bt
dtoverlay=gpio-poweroff,gpiopin=22,active_low
dtoverlay=gpio-shutdown,gpio_pin=17,active_low=0,gpio_pull=down
dtoverlay=gpio-ir
dtparam=gpio_in_pin=26
After removing them and rebooting everything works as it should. Again pasting them in and rebooting -> problem reappears.
My system was updated from 7.0.0 from the mOode position. Should I do a clear install?