Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


support HW
#5
(04-01-2021, 09:06 PM)vinnn Wrote:
(04-01-2021, 06:36 PM)TheOldPresbyope Wrote:
(04-01-2021, 05:55 PM)AndromedaStrain Wrote: can be installed over Khadas VIM3 + Tone1 DAC?

As far as I know the Khadas VIM3 does not support Raspberry Pi OS (formerly known as Raspbian) so I doubt seriously that moOde will run on it. You can try but you will be on your own.

The Tone1 DAC, on the other hand, is just another USB DAC---although a very good one---which works fine when driven by moOde running on an RPi. I should know; I have had one in daily use since I bought it 18 months ago.

Regards,
Kent

You're right Kent, the Khadas VIM is an AMLogic SoC based board which is a different architecture to the Pi's ARM v7 SoC. Not compatible with the Pi at all.
and what can you tell me and explain about the fact that Volumio works on VIM platforms while MoOde does not
... mmmm it seems a strange thought to me ...
Reply


Messages In This Thread
support HW - by AndromedaStrain - 04-01-2021, 05:55 PM
RE: support HW - by TheOldPresbyope - 04-01-2021, 06:36 PM
RE: support HW - by vinnn - 04-01-2021, 09:06 PM
RE: support HW - by AndromedaStrain - 04-01-2021, 11:05 PM
RE: support HW - by Tim Curtis - 04-01-2021, 11:22 PM
RE: support HW - by AndromedaStrain - 04-01-2021, 10:54 PM
RE: support HW - by TheOldPresbyope - 04-01-2021, 11:18 PM

Forum Jump: