01-11-2019, 04:41 PM
(01-11-2019, 09:52 AM)olisturm Wrote: Based on the description, it seems to me that /dev/ttyAMA0 should always be available if Bluetooth is installed, whether it's separate or not. The current setup assumes /dev/serial1, which is only there in some cases. The main scenario that doesn't seem to be covered when using /dev/ttyAMA0 as a dependency is that where no Bluetooth hardware is available at all - in that case the boot process is slowed down drastically because it waits for the timeout.
Oli
Hi, Oli.
I don't disagree. I was just trying to think of all possibilities.
Regards,
Kent
