Step by step guide for using IR remote with moOde

[kwijibo]

Great step by step!

Still works very well under moOde 8.3.8 on pi4, pi-dac pro audio IQ, TSOP4838 and justboom remote control.
Thank you for sharing Drone7

[PeterLustig33]

Hello everyone,

I need your support. I am trying to install an IR remote control with moOde. 
Everything works up to the point "ls /var/run/lirc/" 
At this point "mode2 -d /dev/lirc0" I see the raw data. 
There is a ready-made template for my remote control which I have entered in "lircrc.conf".
Everything works up to the point "ls /var/run/lirc/"

The test with "irw" and "irexec" unfortunately shows nothing. I suspect that no mapping of the raw data with the values in the "lircrc.conf" does not work. 
What am I doing wrong, or where can I check the process?

Thanks and best regards
Peter

[PeterLustig33]

I'll answer myself. On the 5th new attempt, it suddenly worked. This time I followed these instructions for the installation: https://moodeaudio.org/forum/showthread....7#pid19197
I then continued here for the configuration. Everything is working now.