Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


HDMI Monitor says 'Signal out of range"
#4
I have an rPi (3 model B) running the latest image. It works, and I can access it's web page via my LAN. In system settings HDMI is switched on.

So, I turned it off, plugged a HDMI cable into it and into my monitor, and powered up. The monitor just flickered. I swapped the cable to a second monitor, and it said 'signal out of range'.

I powered down the rpi, and put in a raspbian desktop image - and it booted and displayed fine. I powered down again, and put back the moOde image, but as it boots up nothing shows now - just a blank screen.

I might try putting a fresh image on a new disk and try again.
Reply


Messages In This Thread
RE: HDMI Monitor says 'Signal out of range" - by inthemoode - 12-12-2019, 05:39 AM

Forum Jump: