HDMI Monitor says 'Signal out of range"

[DRONE7]

but I thought it would bring up an interface for moOde.

confused here ...you seem to alternate between wanting a cli output and a GUI....

as previous....

in system config tab have you turned on the local display option ?

Or do you just want a terminal display ?

OK, went to the shed...found an HDMI monitor ...came inside..plugged to Pi reboot with the following
disable_splash=1
disable_overscan=1
hdmi_drive=1
#hdmi_blanking=1
dtparam=i2c_arm=on
dtparam=i2s=on
dtparam=audio=off
dtoverlay=allo-piano-dac-plus-pcm512x-audio,glb_mclk
dtoverlay=pi3-disable-wifi
dtoverlay=pi3-disable-bt
arm_64bit=1


and in the system configuration tab....HDMI ON and Local Display ON
Reboot....and WAIT.... screen comes up to MoOde GUI interface.

So, agree with Tim...all good and must be something at your end....check your cables