Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


Official moOde 7.1.0 support thread
#83
Not sure if this has been reported elsewhere, but if I select a crossfeed, parametric EQ, graphic EQ or similar, then open the CamillaDSP page and select a configuration (say, quick convolution) and press save, the Camilla configuration becomes active but all the "set" buttons for the DSP and equalisers on the audio config page become inactive. If it were a crossfeed that was selected it claims it is still active, whereas the others set themselves to off. I'm pretty sure the crossfeed isn't active in this situation.

In short, the mutual exclusivity of the DSP operations is enforced correctly on the Audio Configuration page, but can be broken by turning CamillaDSP on from the CamillaDSP page while something else is selected on the Audio Configuration page.
----------------
Robert
Reply


Messages In This Thread
Thumbnail resolution issues - by chano22000 - 03-20-2021, 08:20 PM
RE: Thumbnail resolution issues - by Tim Curtis - 03-20-2021, 09:30 PM
RE: Official moOde 7.1.0 support thread - by the_bertrum - 03-23-2021, 09:01 AM
Bluetooth on pi zero wh - by KeithC - 04-01-2021, 12:35 AM
RE: Bluetooth on pi zero wh - by KeithC - 04-01-2021, 10:25 PM
RE: Bluetooth on pi zero wh - by TheOldPresbyope - 04-01-2021, 11:46 PM

Forum Jump: