Thank you for your donation!


Instruction Guide LCD/OLED display using pydPiper
Hi Remy,

could you please give me the wiring from RPI3b to 4 way display

GND - 9
VCC - 1
SCL - 5
SDA - 3
Reply
Please let me know where I connect the wires of the display

Thanks.
Jem
Reply
Hi Folks:

I have had a Mode system running fine for several months.  For various reasons, I decided to do a fresh install when I encountered a problem installing Docker.  Does anyone have any suggestions as to what the issue may be?  I have attached the error message below:

+ sh -c apt-get update -qq >/dev/null
E: Repository 'http://raspbian.raspberrypi.org/raspbian buster InRelease' changed its 'Suite' value from 'stable' to 'oldstable'
Enabling docker

Failed to enable unit: Unit file docker.service does not exist.
Failed to start docker.service: Unit docker.service not found.
sudo: docker: command not found
Reply
Raspberry Pi O/S is being prepared for the move from Buster to Bullseye...
https://www.raspberrypi.org/forums/viewt...6&t=318302

Similar question asked and answered here...
https://moodeaudio.org/forum/showthread....3#pid36693

Try a  sudo apt update  (not upgrade !)  and note these lines

Code:
E: Repository 'http://raspbian.raspberrypi.org/raspbian buster InRelease' changed its 'Suite' value from 'stable' to 'oldstable'
N: This must be accepted explicitly before updates for this repository can be applied. See apt-secure(8) manpage for details.
Do you want to accept these changes and continue updating from this repository? [y/N] Y

Reply
(09-22-2021, 10:41 PM)DRONE7 Wrote: Raspberry Pi O/S is being prepared for the move from Buster to Bullseye...
https://www.raspberrypi.org/forums/viewt...6&t=318302

Similar question asked and answered here...
https://moodeaudio.org/forum/showthread....3#pid36693

Try a  sudo apt update  (not upgrade !)  and note these lines

Code:
E: Repository 'http://raspbian.raspberrypi.org/raspbian buster InRelease' changed its 'Suite' value from 'stable' to 'oldstable'
N: This must be accepted explicitly before updates for this repository can be applied. See apt-secure(8) manpage for details.
Do you want to accept these changes and continue updating from this repository? [y/N] Y

Thanks so much.  That solved the issue.
Reply
Is there a way to restart pydPiper when after editing the pages config file?  I have been shutting down and restarting Moode.  I'm sure there is a better way.
Reply
(09-23-2021, 02:57 PM)Wallyboy Wrote: Is there a way to restart pydPiper when after editing the pages config file?  I have been shutting down and restarting Moode.  I'm sure there is a better way.

You could try

Code:
sudo systemctl start pydpiper

Reply
(09-23-2021, 07:26 PM)DRONE7 Wrote:
(09-23-2021, 02:57 PM)Wallyboy Wrote: Is there a way to restart pydPiper when after editing the pages config file?  I have been shutting down and restarting Moode.  I'm sure there is a better way.

You could try

Code:
sudo systemctl start pydpiper

Thanks:  works fine
Reply


Forum Jump: