Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


Instruction Guide DIY USB Consumer Controller
#5
(06-11-2022, 02:43 AM)DRONE7 Wrote: This is installed and configured on another board (such as a Zero) which is then connected via usb to the Pi running Moode and acts as a controller using the buttons connected to the Zero ???   Do  I have that right ?

Installed and configured on another board, yes. But not like a Zero et al. Load the project on a microcontroller board capable of running CircuitPython such as these.

For example, I've tested on RP2040 based boards, SAMD51 based boards, and SAMD21 based boards.

Edit: It may be possible to run this on a Zero as they can run CircuitPython. I haven't tried TBH. I'm doubtful about the USB connectivity from a Zero. I know it's theoretically possible to do, but I don't think CircuitPython for *nix is that advanced.
Reply


Messages In This Thread
DIY USB Consumer Controller - by wdyn1 - 06-10-2022, 03:17 AM
RE: DIY USB Consumer Controller - by Tim Curtis - 06-10-2022, 10:54 AM
RE: DIY USB Consumer Controller - by wdyn1 - 06-11-2022, 02:32 AM
RE: DIY USB Consumer Controller - by DRONE7 - 06-11-2022, 02:43 AM
RE: DIY USB Consumer Controller - by wdyn1 - 06-11-2022, 03:41 AM
RE: DIY USB Consumer Controller - by DRONE7 - 06-11-2022, 06:27 AM
RE: DIY USB Consumer Controller - by wdyn1 - 06-11-2022, 12:47 PM
RE: DIY USB Consumer Controller - by wdyn1 - 06-11-2022, 04:12 PM

Forum Jump: