11-12-2018, 07:43 PM
(This post was last modified: 11-12-2018, 07:44 PM by DaxTrajero.)
I'm booting moode for the first time, v4_3
local install on a pi zero
runs through the logs on screen then gets up to something about "finishing up" and the screen goes blank (monitor says there's still a signal being supplied by the PI) but just a blank screen
any ideas? I was hoping to reach a point where I could manually type in the WIFI details, etc...
local install on a pi zero
runs through the logs on screen then gets up to something about "finishing up" and the screen goes blank (monitor says there's still a signal being supplied by the PI) but just a blank screen
any ideas? I was hoping to reach a point where I could manually type in the WIFI details, etc...