What GPIO pin to be used for Moode

[daniel4381]

I am assembling Soekris DAM1021 with rpi. I don't find any clear guidelines as how to connect rpi i2s with dam1021 to use Moode player. Can someone please guide me, what are the GPIO pins to be used. Do I need to use any code/script to activate the connectio.  Best regards

[TheOldPresbyope]

I am assembling Soekris DAM1021 with rpi. I don't find any clear guidelines as how to connect rpi i2s with dam1021 to use Moode player. Can someone please guide me, what are the GPIO pins to be used. Do I need to use any code/script to activate the connectio.  Best regards

Google is your friend. When I searched on "Soekris DAM1021 with rpi" the first result was Queries on Soekris DAM1021 module and Raspberry Pi.

"Soekris DAM1021/1121" is one of the choices for i2s audio device in moOde Audio Config page so just follow normal setup procedure.

Regards,
Kent

[Tim Curtis]

Just remember that if U.FL cables are not used for the I2S cable assembly then audio distortion is likely.

[daniel4381]

Just remember that if U.FL cables are not used for the I2S cable assembly then audio distortion is likely.

Thanks for the suggestion. Please forgive my ignorance,  I am a novice. I coubd not find U.FL cable at my area.  Is it shielded cable you are talking about? I am using a i2s switch to switch between USB and rpi. Do I have to use shielded cable for all the i2s connections?

[daniel4381]

I am assembling Soekris DAM1021 with rpi. I don't find any clear guidelines as how to connect rpi i2s with dam1021 to use Moode player. Can someone please guide me, what are the GPIO pins to be used. Do I need to use any code/script to activate the connectio.  Best regards

Google is your friend. When I searched on "Soekris DAM1021 with rpi" the first result was Queries on Soekris DAM1021 module and Raspberry Pi.

"Soekris DAM1021/1121" is one of the choices for i2s audio device in moOde Audio Config page so just follow normal setup procedure.

Regards,
Kent

Thanks for the help, I have understood the settings.

[Tim Curtis]

Just remember that if U.FL cables are not used for the I2S cable assembly then audio distortion is likely.

Thanks for the suggestion. Please forgive my ignorance,  I am a novice. I coubd not find U.FL cable at my area.  Is it shielded cable you are talking about? I am using a i2s switch to switch between USB and rpi. Do I have to use shielded cable for all the i2s connections?

I would suggest asking on the Soekris thread at diyAudio.
https://www.diyaudio.com/forums/vendor-s...4-khz.html

Here is an example uf U.FL interconnect between Pi and DAC using parts from @iancanada.
https://www.diyaudio.com/forums/digital-...r-367.html
https://www.diyaudio.com/forums/group-bu...y-243.html

-Tim