10-15-2022, 12:59 PM
The TFT is for a RASPI and certainly looks similar a report for a different RASPI TFT with problems. Running on a 3B+.
I know this has been covered elsewhere for a different TFT, but the setup for the adafruit device is somewhat different and I was hoping there might be someone out there who already has this working.
I ran the setup and configured the screen to use fbcp, HDMI is enabled in the MoodeUI.
The adafruit setup modifies config.txt and adds the following:
I don't see changes in /boot/cmdline.txt, /etc/rc.local.
Is there anything else I need to look at?
Googling hasn't helped much other than pointing me at the Adafruit site where the installation guide resides.
Honestly, it's not the most important thing in the world ATM, it's curiosity mostly, though I'd like to get it working. I had the screen in a box of bits left over from another project that changed direction...
I know this has been covered elsewhere for a different TFT, but the setup for the adafruit device is somewhat different and I was hoping there might be someone out there who already has this working.
I ran the setup and configured the screen to use fbcp, HDMI is enabled in the MoodeUI.
The adafruit setup modifies config.txt and adds the following:
Code:
[all]
hdmi_force_hotplug=1
dtparam=spi=on
dtparam=i2c1=on
dtparam=i2c_arm=on
dtoverlay=pitft35-resistive,rotate=90,speed=20000000,fps=20I don't see changes in /boot/cmdline.txt, /etc/rc.local.
Is there anything else I need to look at?
Googling hasn't helped much other than pointing me at the Adafruit site where the installation guide resides.
Honestly, it's not the most important thing in the world ATM, it's curiosity mostly, though I'd like to get it working. I had the screen in a box of bits left over from another project that changed direction...
