Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


Problem: DACBerry ONE+ TOSLINK input
#11
(06-16-2020, 09:41 AM)the_bertrum Wrote:
(06-15-2020, 10:44 AM)Cardone Wrote: Hello, you could maybe try it with the setting dtoverlay = hifiberry-dacplus

No dice I'm afraid, nothing on the digital inputs and the MPD gives an unknown device ALSA error.  From what I can tell with my limited knowledge and the few places where I can find this board discussed, it is set up such that the I2S input is fed through one of the DAC chips and out to the Phono output, while the digital input is fed through the other DAC chip and out to the digital output.  For what purpose that would be I can't fathom.

How are the solder jumpers set on your boards?
I saw an eBay feedback of a buyer saying the solder jumpers were not in default configuration and had to solder, which got it going. I am searching to see if anyone got the toslink input to feed out the analogue outputs.
Reply
#12
My goodness this was a long time ago. I've given up on getting any digital input from this device and have settled for it being just a simple I2S DAC, albeit an expensive one with lots of unused electronics on it.
----------------
Robert
Reply


Forum Jump: