[PROBLEM] Installed 6.x - USB media not working (ARM6)

[drivedesigned]

Hi There,

Just having a bit of trouble with USB media on both v6.0 and v6.1 of moode. In both cases I've been trying to diagnose the issue on a fresh install with both an externally powered hard drive as well as a USB flash drive, and both devices DO work if I install a fresh version of v5.3.1. I'm using a Raspberry Pi Zero W.

I've tried to troubleshoot the problem myself, working my way through this thread in particular: http://moodeaudio.org/forum/showthread.php?tid=894 so I'll share my findings thus far.

- if I connect one of the drives and run MPD Update, 'USB' is listed in the media browser, but the folder is empty and likewise nothing is listed in the filter browser.
cat /var/log/mpd/log also returns nothing.
- if I run MPD Re-Gen instead the 'USB' listing disappears, and the mpd log simply lists "Aug 25 23:34 : update: updating SDCARD/Stereo Test/LRMonoPhase4.flac"

- the syslog contains this:

Code:

Aug 25 23:24:08 moode kernel: [  979.744877] usb 1-1: USB disconnect, device number 2
Aug 25 23:24:14 moode kernel: [  985.695276] Indeed it is in host mode hprt0 = 00021501
Aug 25 23:24:14 moode kernel: [  985.905149] usb 1-1: new high-speed USB device number 3 using dwc_otg
Aug 25 23:24:14 moode kernel: [  985.905323] Indeed it is in host mode hprt0 = 00001101
Aug 25 23:24:14 moode kernel: [  986.146080] usb 1-1: New USB device found, idVendor=0781, idProduct=5572, bcdDevice= 1.26
Aug 25 23:24:14 moode kernel: [  986.146100] usb 1-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
Aug 25 23:24:14 moode kernel: [  986.146109] usb 1-1: Product: Cruzer Switch
Aug 25 23:24:14 moode kernel: [  986.146118] usb 1-1: Manufacturer: SanDisk
Aug 25 23:24:14 moode kernel: [  986.146125] usb 1-1: SerialNumber: 20052444311AFB219998
Aug 25 23:24:14 moode kernel: [  986.151095] usb-storage 1-1:1.0: USB Mass Storage device detected
Aug 25 23:24:14 moode kernel: [  986.167580] scsi host0: usb-storage 1-1:1.0
Aug 25 23:24:14 moode mtp-probe: checking bus 1, device 3: "/sys/devices/platform/soc/20980000.usb/usb1/1-1"
Aug 25 23:24:14 moode mtp-probe: bus: 1, device: 3 was not an MTP device
Aug 25 23:24:14 moode mtp-probe: checking bus 1, device 3: "/sys/devices/platform/soc/20980000.usb/usb1/1-1"
Aug 25 23:24:14 moode mtp-probe: bus: 1, device: 3 was not an MTP device
Aug 25 23:24:15 moode kernel: [  987.186672] scsi 0:0:0:0: Direct-Access     SanDisk  Cruzer Switch    1.26 PQ: 0 ANSI: 6
Aug 25 23:24:15 moode kernel: [  987.190814] sd 0:0:0:0: [sda] 15633408 512-byte logical blocks: (8.00 GB/7.45 GiB)
Aug 25 23:24:15 moode kernel: [  987.191340] sd 0:0:0:0: Attached scsi generic sg0 type 0
Aug 25 23:24:15 moode kernel: [  987.192090] sd 0:0:0:0: [sda] Write Protect is off
Aug 25 23:24:15 moode kernel: [  987.192108] sd 0:0:0:0: [sda] Mode Sense: 43 00 00 00
Aug 25 23:24:15 moode kernel: [  987.192895] sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
Aug 25 23:24:15 moode kernel: [  987.225632]  sda: sda1
Aug 25 23:24:15 moode kernel: [  987.230068] sd 0:0:0:0: [sda] Attached SCSI removable disk
Aug 25 23:24:15 moode systemd-udevd[2380]: Process 'udisks-part-id /dev/sda' terminated by signal SEGV.
Aug 25 23:24:15 moode systemd-udevd[2380]: Failed to wait for spawned command 'udisks-part-id /dev/sda': Input/output error
Aug 25 23:24:16 moode systemd-udevd[2366]: Process 'udisks-part-id /dev/sda1' terminated by signal SEGV.
Aug 25 23:24:16 moode systemd-udevd[2366]: Failed to wait for spawned command 'udisks-part-id /dev/sda1': Input/output error

so to continue following along with the other thread, the output of lsusb DOES list my drive, but it is not mounted in /media

if I try to mount the drive manually (to /tmp/mydrive) as suggested on page 2, it works:

Code:

pi@moode:~ $ sudo mkdir /media/mydrive
pi@moode:~ $ sudo mount /dev/sda1 /media/mydrive/
pi@moode:~ $ mount|grep sda
/dev/sda1 on /media/mydrive type fuseblk (rw,relatime,user_id=0,group_id=0,allow_other,blksize=4096)

and from the syslog:

Code:

Aug 25 23:31:41 moode kernel: [ 1433.033016] fuse init (API version 7.27)
Aug 25 23:31:41 moode systemd[1]: Mounting FUSE Control File System...
Aug 25 23:31:41 moode ntfs-3g[2991]: Version 2017.3.23AR.3 integrated FUSE 28
Aug 25 23:31:41 moode ntfs-3g[2991]: Mounted /dev/sda1 (Read-Write, label "DAVE", NTFS 3.1)
Aug 25 23:31:41 moode ntfs-3g[2991]: Cmdline options: rw
Aug 25 23:31:41 moode ntfs-3g[2991]: Mount options: allow_other,nonempty,relatime,rw,fsname=/dev/sda1,blkdev,blksize=4096
Aug 25 23:31:41 moode ntfs-3g[2991]: Ownership and permissions disabled, configuration type 7
Aug 25 23:31:41 moode systemd[1]: Mounted FUSE Control File System.

and then if I run MPD Update... we have music in the library! But I'd still like to get to the bottom of what's going on here and restore the plug 'n' play capabilities if possible.

Thanks very much
Dave

EDIT: my apologies for the duplicate, but it appears I'm having the same issue as Wigwam here: http://moodeaudio.org/forum/showthread.php?tid=1662