I was away when started them all, when I was back the GUI was up on both asking to reboot IIRC, so I did.
How do I get the log Tim? moodeutl -l? The error message showed up with this very moodeult -l result:
How do I get the log Tim? moodeutl -l? The error message showed up with this very moodeult -l result:
Code:
20191010 220223 worker: MPD version (0.20.23)
20191010 220223 worker: CPU governor (performance)
20191010 220223 worker: USB boot not available
20191010 220224 worker: File system expanded
20191010 220224 worker: HDMI port off
20191010 220225 worker: File check (OK)
20191010 220225 worker: -- Network
20191010 220225 worker: eth0 exists
20191010 220225 worker: eth0 (192.168.34.17)
20191010 220225 worker: wlan0 does not exist
20191010 220225 worker: -- Audio
20191010 220225 worker: ALSA outputs unmuted
20191010 220225 worker: ALSA card number (0)
20191010 220225 worker: Audio output (I2S audio device)
20191010 220225 worker: Audio device (Allo DigiOne)
20191010 220226 worker: Supported audio formats (S16_LE, S24_LE)
20191010 220226 worker: ALSA mixer name (Digital)
20191010 220226 worker: MPD volume control (disabled)
20191010 220226 worker: Hdwr volume controller not detected
20191010 220226 worker: -- Services
20191010 220226 worker: Reset renderer active state
20191010 220227 worker: MPD conf updated
20191010 220227 worker: MPD started
20191010 220228 worker: MPD accepting connections
20191010 220228 worker: Configure MPD outputs
20191010 220229 worker: MPD output 1 ALSA default (on)
20191010 220229 worker: MPD output 2 ALSA crossfeed (off)
20191010 220229 worker: MPD output 3 ALSA parametric eq (off)
20191010 220229 worker: MPD output 4 ALSA graphic eq (off)
20191010 220229 worker: MPD output 5 ALSA polarity inversion (off)
20191010 220229 worker: MPD output 6 ALSA bluetooth (off)
20191010 220229 worker: MPD output 7 HTTP stream (off)
20191010 220229 worker: MPD crossfade (off)
20191010 220229 worker: Audio source (Local)
20191010 220229 worker: Output device (Local)
20191010 220229 worker: USB auto-mounter (udisks-glue)
20191010 220229 worker: -- Music sources
20191010 220229 worker: USB sources (none attached)
20191010 220230 worker: NAS and UPnP sources (mountall initiated)
20191010 220230 worker: -- Miscellaneous
20191010 220230 worker: Saved MPD vol level (0)
20191010 220230 worker: Preamp volume level (0)
20191010 220230 worker: MPD volume level (0) restored
20191010 220230 worker: ALSA volume level (None)
20191010 220230 worker: Auto-play (Off)
20191010 220230 worker: Maintenance interval (6 hrs)
20191010 220230 worker: Screen saver activation (Never)
20191010 220230 worker: Session permissions (OK)
20191010 220230 worker: Watchdog started
20191010 220230 worker: Ready