11-16-2019, 10:21 PM
Hi,
I couldn't find an answer to my question and Squeezelite doesn't really fit to my scenario as far as I understood it:
I have 3 rooms, in each of them one raspberry running moode 6.3.
All of them have their own amplifier with speakers.
One of them is the "master" - just because it's the most used room.
It always plays AND streams this music. (What I hear is typically a radio stream or via bluetooth connection.)
The other two "slaves" are turned on manually and then play the stream from the master.
At this point I run into problems. The sound of the slaves is delayed about 2 seconds and that sounds weird if you walk from room to room.
Also if each of them plays the same radio stream with their own connection, the sound differs in time.
I'm pretty sure the most of this time is related to buffering. Is there a way to reduce the buffering in moode?
Another idea were to delay the real audio output to the amplifier of the master.
I don't expect to have it synchronized to 100%, but a simple way to set some kind of delay / and or buffering value would be great.
Any tips or ideas?
Thanks!
I couldn't find an answer to my question and Squeezelite doesn't really fit to my scenario as far as I understood it:
I have 3 rooms, in each of them one raspberry running moode 6.3.
All of them have their own amplifier with speakers.
One of them is the "master" - just because it's the most used room.
It always plays AND streams this music. (What I hear is typically a radio stream or via bluetooth connection.)
The other two "slaves" are turned on manually and then play the stream from the master.
At this point I run into problems. The sound of the slaves is delayed about 2 seconds and that sounds weird if you walk from room to room.
Also if each of them plays the same radio stream with their own connection, the sound differs in time.
I'm pretty sure the most of this time is related to buffering. Is there a way to reduce the buffering in moode?
Another idea were to delay the real audio output to the amplifier of the master.
I don't expect to have it synchronized to 100%, but a simple way to set some kind of delay / and or buffering value would be great.
Any tips or ideas?
Thanks!
