01-02-2020, 04:42 PM
@boring
So Tim said
Since you apparently just started using the USBridge Sig, had you previously used the Amanero/Soekris combination with moOde on an RPi? Were you able to play native DSD on that setup? Or with the Amanero/Soekris combo connected to some other computer?
If so, I would think there is also a possibility your problem arises in the USBridge USB subsystem, possibly in the driver. This would then be a question for Allo support rather than the MPD maintainer.
I have none of the hardware involved. On one system, I do have a Khadas Tone board (USB DAC) plugging into an RPi4B running moOde 6.4.0. According to moOde's Audio info panel, it's outputting native DSD to the KTB.
and
Regards,
Kent
So Tim said
Quote:If you are confident that MPD should be using native DSD instead of DoP
Since you apparently just started using the USBridge Sig, had you previously used the Amanero/Soekris combination with moOde on an RPi? Were you able to play native DSD on that setup? Or with the Amanero/Soekris combo connected to some other computer?
If so, I would think there is also a possibility your problem arises in the USBridge USB subsystem, possibly in the driver. This would then be a question for Allo support rather than the MPD maintainer.
I have none of the hardware involved. On one system, I do have a Khadas Tone board (USB DAC) plugging into an RPi4B running moOde 6.4.0. According to moOde's Audio info panel, it's outputting native DSD to the KTB.
Quote:Audio Information
INPUT / OUTPUT
Source: NAS/OMV-SMB/DSD/NDSD012/03_Welcome-to-NativeDSD-Sampler_NativeDSD- Presents_NDSD012_2ch64.dsf
Encoded at: DSD64, 1 bit, 5.644 Mbps Stereo
Decoded to: DSD bitstream, 5.645 Mbps
Destination: Local
Output rate: DSD bitstream bit, 88.2 kHz, Stereo, 5.645 Mbps
and
Code:
pi@moodeLR:/var/lib/mpd/playlists $ cat /proc/asound/card1/pcm0p/sub0/hw_params
access: RW_INTERLEAVED
format: DSD_U32_BE
subformat: STD
channels: 2
rate: 88200 (88200/1)
period_size: 11025
buffer_size: 44100Regards,
Kent
