Tidal setup

[dbdicker]

@vinnn

You've mixed two different modes of operation together. It's not necessary to enter Tidal credentials in BubbleUPnP. Once moOde has been configured, then any UPnP control point can access Tidal through its (moOde's) media server.

If Tidal credentials are entered into BubbleUPnP, then it can act as a proxy media server for Tidal and no Tidal credentials are necessary in moOde. Just have to browse different directories. Not all UPnP control points have this ability.

Example: I just fired up mconnect-lite to play Tidal via my moOde player. No credentials were entered into mconnect.

Regards,
Kent

Cheers Kent, hadn't realised that.
I just went from my configuration but I do also use BubbleUPnP to throw Tidal at a couple of other devices in the house other than Moode so there ya go.

thanks Kent - for your more sympathetic reply.  I found the issue, it was silly -- needed to turn on local SSH, although I don't remember reading the need to do that elsewhere.

no matter -- I have sent a donation to Moode for the wonderful free software solution and for letting me explore the capabilities of streaming without getting into all that Volumio jazz -- which I definitely did not want to do.  

I'm sure I'll be back with other questions, it would I think help for folks here to realize that some of us have not been with the project from the start and know next to nothing -- but that doesn't mean they are know-nothings.......

regards,

Dan

Good news that it's working, apologies if I sounded unsympathetic it was not intended. Just my harsh North England temperament I suppose.
I'm puzzled about the SSH thing though, that should make no difference.

Yah, me too.....