03-15-2020, 02:00 PM
@DRONE7
I like your straight-ahead approach. Case too big? No problem, let's power up the bandsaw!
If you have other power tools at your disposal, I'd think an custom front plate with a large opening covered from the rear with grillage is in order. Long ago in my salad days I did this for a amateur radio transmitter using just hacksaw, drill, and a couple of files. Once I sanded the front surface it didn't look half-bad, but I don't recommend this approach!
Regards,
Kent
PS - I've noticed too that the forum goes silent once in a while. Random fluctuations in the ether I guess.
I like your straight-ahead approach. Case too big? No problem, let's power up the bandsaw!
If you have other power tools at your disposal, I'd think an custom front plate with a large opening covered from the rear with grillage is in order. Long ago in my salad days I did this for a amateur radio transmitter using just hacksaw, drill, and a couple of files. Once I sanded the front surface it didn't look half-bad, but I don't recommend this approach!
Regards,
Kent
PS - I've noticed too that the forum goes silent once in a while. Random fluctuations in the ether I guess.
