[How To] CD playback

[eslei]

hi, there,

i got moode 6.4.2 on rpi 3b, install moodecdplay but no cd tracks display.

Code:

pi@moode:~ $ cd /home/pi/moOdeCDPlay-master
pi@moode:~/moOdeCDPlay-master $ /bin/bash install.sh
Install V0 moOdeCDPlay files in moOde.
Done - please reboot moOde to complete installation.

that's the installation

Code:

pi@moode:~ $ dmesg | tail -20
[   10.873538] 8021q: adding VLAN 0 to HW filter on device eth0
[   10.882359] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   12.243489] ICMPv6: process `dhcpcd' is using deprecated sysctl (syscall) net.ipv6.neigh.eth0.retrans_time - use net.ipv6.neigh.eth0.retrans_time_ms instead
[   21.662172] FAT-fs (sda1): Volume was not properly unmounted. Some data may be corrupt. Please run fsck.
[  167.402971] usb 1-1.2: new high-speed USB device number 6 using dwc_otg
[  167.534437] usb 1-1.2: New USB device found, idVendor=05e3, idProduct=0701, bcdDevice= 0.02
[  167.534452] usb 1-1.2: New USB device strings: Mfr=0, Product=1, SerialNumber=0
[  167.534462] usb 1-1.2: Product: USB TO IDE
[  167.535420] usb-storage 1-1.2:1.0: USB Mass Storage device detected
[  167.535844] usb-storage 1-1.2:1.0: Quirks match for vid 05e3 pid 0701: 520
[  167.535966] scsi host1: usb-storage 1-1.2:1.0
[  168.616024] scsi 1:0:0:0: CD-ROM            TSSTcorp CD/DVDW SH-W162Z TS01 PQ: 0 ANSI: 0
[  168.616795] scsi 1:0:0:0: Attached scsi generic sg1 type 5
[  168.679480] sr 1:0:0:0: Power-on or device reset occurred
[  168.745379] sr 1:0:0:0: [sr0] scsi3-mmc drive: 8x/48x writer cd/rw xa/form2 cdda tray
[  168.745392] cdrom: Uniform CD-ROM driver Revision: 3.20
[  168.746641] sr 1:0:0:0: Attached scsi CD-ROM sr0
[  169.133001] usb 1-1.2: reset high-speed USB device number 6 using dwc_otg
[  182.513301] usb 1-1.2: USB disconnect, device number 6
[  182.532881] scsi 1:0:0:0: rejecting I/O to dead device

the cd drive is in the system





any guidance and suggestions are appreciated.