06-10-2018, 12:17 AM
To troubleshoot its necessary to first determine if WiFi issue.
- Connect the Pi via Ethernet to your Router
- Configure, Network and set wlan0 SSID to 'blank' then APPLY
- Reboot
Note that AP mode will not be activated when connected via Ethernet.
Run some Airplay tests and post back results. If it fails over Ethernet then there is a procedure for running the Airplay receiver in debug mode which can sometimes show where the problem is.
-Tim
- Connect the Pi via Ethernet to your Router
- Configure, Network and set wlan0 SSID to 'blank' then APPLY
- Reboot
Note that AP mode will not be activated when connected via Ethernet.
Run some Airplay tests and post back results. If it fails over Ethernet then there is a procedure for running the Airplay receiver in debug mode which can sometimes show where the problem is.
-Tim
