04-12-2020, 10:12 AM
(This post was last modified: 04-12-2020, 10:16 AM by sisim.
Edit Reason: remove picture which was not displayed
)
Hello,
I just switched from Volumio to Moode and I'm very satisfied, the software is working much better!
I have set up the GPIO button handler to ON and tried to configure the GPIO but it's not working :
I know that the hardware is OK because it was working on Volumio (https://github.com/tomatpasser/gpio-buttons). What I tried:
- Pin 16 : mpc stop
- Pin 24 : /var/www/vol.sh up 1
- Pin 17: mpc next
Is there something else I need to do? How could I investigate?
Also, I have another question: is there a possibility to configure different functions if I do a long press? I see for example in https://github.com/bnielsen1965/rpi-gpio-buttons that the option pressed sets the timing.
Thanks for your support!
I just switched from Volumio to Moode and I'm very satisfied, the software is working much better!
I have set up the GPIO button handler to ON and tried to configure the GPIO but it's not working :
I know that the hardware is OK because it was working on Volumio (https://github.com/tomatpasser/gpio-buttons). What I tried:- Pin 16 : mpc stop
- Pin 24 : /var/www/vol.sh up 1
- Pin 17: mpc next
Is there something else I need to do? How could I investigate?
Also, I have another question: is there a possibility to configure different functions if I do a long press? I see for example in https://github.com/bnielsen1965/rpi-gpio-buttons that the option pressed sets the timing.
Thanks for your support!
